systemd-journald: Received request to flush runtime journal from PID 1
brcmfmac mmc1:0001:1: Direct firmware load for brcm/brcmfmac43455-sdio.bin failed with error -2
usbcore: registered new interface driver brcmfmac This is dmesg output: brcmfmac: F1 signature read 4.395773] brcmfmac: brcmf_fw_map_chip_to_name: using brcm/brcmfmac43455-sdio.bin for chip 0x004345(17221) rev 0x000006 Ethernet work on Raspberry pi 3 B+ but still wifi not work. After i put SD card on Raspberry pi 3 B+ the USB works but Ethernet and wifi still not work.ĮDIT 2 - After re-installing Raspbian 8 and made rpi-update on Raspberry pi 3. ( start.elf, start_cd.elf, start_db.elf, start_x.elf, bcm2708-rpi-0-w.dtb, bcm2708-rpi-b.dtb, bcm2708-rpi-plus.dtb, bcm2708-rpi-cm.dtb, bcm2709-rpi-2-b.dtb, bcm2710-rpi-3-b.dtb, bcm2710-rpi-3-b-plus.dtb, bcm2710-rpi-cm3.dtb, fixup.dat, fixup_cd.dat, fixup_bd.dat, fixup_x.dat) With the files in Raspbian Stretch /boot and the Pi 3 B+ boots but the USB and Ethernet ports do not work.ĮDIT - I have tested rpi-update on Raspberry pi 3. Mmal: Failed to run camera app.How can I can use my old Raspbian 8 (Jessie) SD card installation on the Pi 3 B+? Mmal: main: Failed to create camera component Mmal: camera component couldn't be enabled Mmal: mmal_vc_component_enable: failed to enable component: ENOSPC Possible Issue: Raspberry Pi HD Camera - ENOSPC errorĪfter activating the GPU acceleration in Chromium, I got the following error while trying to take a photo with the HD camera and playing some Youtube video. That should resolve most issues! I still noticed a bit of screen tearing.
After restarting the web browser, you can refresh chrome://gpu and you will get Fig. Hardware-accelerated video decode (only available on the new versions of Raspberry Pi OS)Īnd change those settings to Enabled (see Fig.To change that, we need to go to chrome://flags and search for If open a Chromium and go to chrome://gpu, you will still get Fig.
Once your Raspberry reboots, you can check that the 3D drivers are loaded and working: cat on Raspberry Pi 3 the v3dbus command should be (provided by Alexis in the comments):Ĭat both commands return okay, then the hardware acceleration is working and activated. Note: if you're new to this configurator, you can navigate the menu using the arrows and the tab key from your keyboard.
Then, install the libraries typing: sudo apt-get install libgles2-mesa libgles2-mesa-dev xorg-dev
You need to install a few libraries, but first, the basic step is to update the system typing the following on a Terminal: sudo apt-get update DIY: Video Decode using Hardware Acceleration